Featured Photo Click to View The Market Tractor Parts Tractor Manuals Classified Ads Tractor Shoppe Features Discussion Forum Archives Tractor Photos Implement Photos Combine Photos Information Model Profiles Safety Issues Manufacturers Reading Room Miscellaneous Contact Us Tractor Shoppe Antique Tractors Classic Trucks Kountry Life YT Forums Discount Parts [Home]

Modern Tractor Discussion Board Topic: Re: FORD 8210 Torque specs [Show Entire Topic] [Return to Forum] Author [expand] [Modern View] RodInNS 08-05-2009 04:57:31 216.118.158.123 20761 Report to Moderator They are head bolts... just a bit longer. Torque is the same. A 9/16" bolt should torque in three stages at 90, 100, and 110 ft-lb. Chase the holes with a bottoming tap... I beleive the sequence is as follows... you start on the right side, middle outside bolt, follow to the left middle outside, then forward to the right inside, then left inside, then rearward to the right inside followed by the left inside... then forward and repeat until you're done. Then to the next stage, repeat the sequence, then the last stage. I'm just going by memory on that... so check that this sequence will have you arrive at the front and back of the head at the same time. If it doesn't adjust your starting point so that it does. Also... if you have 1/2" head bolts, post back and I'll check the torque values. Rod [Reply]  [Send Email] [Show Entire Topic]   [Options]  [Printer Friendly]  [Return to Forum]   [Add a Reply] Hop to: Another Forum Tractor Talk Tool Talk Restoration Tips Paint & Bodywork Implement Alley Tractor Transporting Allis Chalmers Case Combines Crawlers Farmall & IH Ford Ford 9N,2N & 8N Fordson John Deere MH & MF Harry Ferguson Minneapolis Moline Oliver & Cockshutt Garden Tractors Orphans Stationary Engines Today's Tractors Memorabilia Tractor Tales Using Your Tractor Tractor Pulling Site Comments Test Forum Buyer Seller Feedback Kountry Life Classic Trucks