Home | Gallery | Forum | Ads TODAYSTRACTORS.COM
Today's TractorsThe Modern Tractor Resource Page

Featured Photo

Click to View

The Market
Tractor Parts
Older Parts
Tractor Manuals
Classified Ads

Discussion Forum
Forum Archives
Tractor Photos
Implement Photos
Combine Photos
Model Profiles
Safety Issues
Reading Room

Contact Us

Modern Tractor Discussion Board

Topic: Case 2094 Lube pressure
[Return to Forum]

Author [expand] [Modern View]

04-23-2014 18:52:18

Report to Moderator

I have a 2094 in the shop that has me stumped. Just did a complete trans rebuild (gear and powershift). Checking pressures at startup and regulated/ clutch pressures are all good. Lube pressure is at 40-50 psi with powershift in low or high, but drops to near 0 in intermediate. The I-T service manual states that the lube should be at 210 in all 3 speeds. I"m not sure that this is correct.
Flow tested the gear pump and it is OK.
Any help would be greatly appreciated.

[Reply]  [Send Email]

[Options]  [Printer Friendly]  [Return to Forum]   [Add a Reply]

Hop to:
12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.    [Click here to visit this Sponsor]


Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com

Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.