Topic: Re: Belarus 250AS clutch???
|Modern Tractor Discussion Board|
[Return to Forum]
[Return to Forum]
[Add a Reply]
I installed a new clutch disc on a 1995 Belarus
250AS but am having trouble getting the three-
fingered pressure plate adjusted.
How do you adjust the pressure plate?
Are there specs or tolerances? My owner"s manual
shows how to adjust the clutch pedal free travel,
but not how to adjust the 3-fingered pressure
plate. I know how to access the pressure plate,
Can anyone help?
|[Reply] [Send Email] |
| Not owing a 250, but have a 420A, not able to look it up but i would suggest that you adjust all three fingers to some distance from the pressure plate contact point, for example adjusting bolt head, some "X" distance from the plate or flywheel. |
then tighten each adjusting in the same amount either by counting bolt flats? or measuring with a caliper of some sort.Also consider the throw out bearing adjustment, not touching/turning when the clutch pedal is up[ as in tractor moving] about a .500/.750 of slack in pedal movement, until you feel the bearing coming against the fingers.
Turn the fingers in until just about to touch the clutch plate, but not lifting the plate.
hope it helps
[Reply] [No Email]
|12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|