Home | Gallery | Forum | Ads TODAYSTRACTORS.COM
Today's TractorsThe Modern Tractor Resource Page

 
Featured Photo

Click to View

The Market
Tractor Parts
Older Parts
Tractor Manuals
Classified Ads

Features
Discussion Forum
Forum Archives
Tractor Photos
Implement Photos
Combine Photos
Information
Model Profiles
Safety Issues
Manufacturers
Reading Room

Miscellaneous
Contact Us

[Home]
  
Modern Tractor Discussion Board

Topic: Kubota M110 4x4 front drive shaft
[Return to Forum]

Author [expand] [Modern View]
Tim GA

03-13-2015 18:41:54
205.144.215.135
23922



Report to Moderator


Trying to remove the front drive shaft shield. at the front removed bolt, slide shield back, removed roll pin and slide drive shaft coupler back. Drive shaft will not drop enough to remove the shield. It looks like the engine oil pan goes under and on both sides of the shaft. does the oil pan need to be removed?? or what needs to be done?? Tim

[Reply]  [Send Email]
Tx Jim

03-14-2015 03:24:02
69.35.163.57
23923



Report to Moderator

Re: Kubota M110 4x4 front drive shaft in reply to Tim GA, 03-13-2015 18:41:54  
From viewing parts schematic for a M110 it appears the engine oil pan straddles MFWD drive shaft but does not enclose drive shaft. I know that's the way my M7040 is IE driveshaft will come off tractor with engine oil pan remaining on engine.

  [Reply]  [No Email]
Tim GA

03-21-2015 06:13:42
205.144.215.151
23925



Report to Moderator

Re: Kubota M110 4x4 front drive shaft in reply to Tx Jim, 03-14-2015 03:24:02  
Up date on removing the front drive shaft assembly. The drive shaft could not be removed without unbolting both axle supports and rolling the axle forward about 6 inches. the oil pan not only saddles the driveshaft but also goes under the shaft. The driveshaft rear coupler in the clutch housing will not come forward or rearward enough to release the driveshaft. The driveshaft cove broke in two because the rear support bushing was almost gone. Thanks for your help. Tim

  [Reply]  [Send Email]
Ken Macfarlane

03-26-2015 08:21:49
142.166.168.2
23926



Report to Moderator

Re: Kubota M110 4x4 front drive shaft in reply to Tim GA, 03-21-2015 06:13:42  
Similar trouble on my MF only it broke the pinion on the front axle. Rear bearing wasn"t greased in the 4000 hours before I bought it.

  [Reply]  [Send Email]

[Options]  [Printer Friendly]  [Return to Forum]   [Add a Reply]

Hop to:
Advertisement
12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.    [Click here to visit this Sponsor]

Home

Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com

Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.