Home | Gallery | Forum | Ads TODAYSTRACTORS.COM
Today's TractorsThe Modern Tractor Resource Page

Featured Photo

Click to View

The Market
Tractor Parts
Older Parts
Tractor Manuals
Classified Ads

Discussion Forum
Forum Archives
Tractor Photos
Implement Photos
Combine Photos
Model Profiles
Safety Issues
Reading Room

Contact Us

Modern Tractor Discussion Board

Topic: Re: Kubota M110 4x4 front drive shaft
[Show Entire Topic] [Return to Forum]

Author [expand] [Modern View]
Tim GA

03-21-2015 06:13:42

Report to Moderator

Up date on removing the front drive shaft assembly. The drive shaft could not be removed without unbolting both axle supports and rolling the axle forward about 6 inches. the oil pan not only saddles the driveshaft but also goes under the shaft. The driveshaft rear coupler in the clutch housing will not come forward or rearward enough to release the driveshaft. The driveshaft cove broke in two because the rear support bushing was almost gone. Thanks for your help. Tim

[Reply]  [Send Email]
Ken Macfarlane

03-26-2015 08:21:49

Report to Moderator

Similar trouble on my MF only it broke the pinion on the front axle. Rear bearing wasn"t greased in the 4000 hours before I bought it.

  [Reply]  [Send Email]

[Show Entire Topic]   [Options]  [Printer Friendly]  [Return to Forum]   [Add a Reply]

Hop to:
12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.    [Click here to visit this Sponsor]


Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com

Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.