Home | Gallery | Forum | Ads TODAYSTRACTORS.COM
Today's TractorsThe Modern Tractor Resource Page

Featured Photo

Click to View

The Market
Tractor Parts
Older Parts
Tractor Manuals
Classified Ads

Discussion Forum
Forum Archives
Tractor Photos
Implement Photos
Combine Photos
Model Profiles
Safety Issues
Reading Room

Contact Us

Machinery Forum

JD 5400 hard shifting

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Roger on February 12, 2001 at 18:12:49 from (

The dealer put in a new clutch in my JD 5400 w/TSS trans about six months ago, and it has gotten harder to shift since. They did take the tractor "in two" for the clutch job. Sometimes I need to let the tractor roll a little to get it into gear. I heard about greasing a spline on yesterdays tractor forum. Can this be done without pulling the tractor in half? I was hoping the problem was in the shift linkage on top of the transmission.

Follow Ups:

Post A Followup


Subject: Re: JD 5400 hard shifting


Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.    [Click here to visit this Sponsor]


Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com

Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.