Home | Gallery | Forum | Ads TODAYSTRACTORS.COM
Today's TractorsThe Modern Tractor Resource Page

 
Featured Photo

Click to View

The Market
Tractor Parts
Older Parts
Tractor Manuals
Classified Ads

Features
Discussion Forum
Forum Archives
Tractor Photos
Implement Photos
Combine Photos
Information
Model Profiles
Safety Issues
Manufacturers
Reading Room

Miscellaneous
Contact Us

[Home]
  
Farm Tractors & Machinery Forum

Re: Long 460 pto questions


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by KEH on August 25, 2007 at 12:31:21 from (209.213.31.0):

In Reply to: Long 460 pto questions posted by Rick on August 24, 2007 at 19:12:18:


Long 460 has a 2 faced clutch. One side delivers power to the transmission, the other side to the pto. The lever to the left of the steering wheel which pivots on the left of the transmission case is the pto clutch lever. It supplies independent pto. There is no 2 speed pto. There is a high-low lever for the transmission, but this affects ground speed, not pto.
There is a pto gear lever mounted horizontally on the left top of the transmission case. There are 2 types of pto operation, independent and ground speed. The ground speed only works when the transmission is in gear and the foot clutch is out. To engage ground speed pto, run tractor at slow idle, push foot clutch in, mover pto gear lever to the right. Pto gears may grind and you can avoid this by cutting tractor off. For independant pto operation, which is preferred, raise pto clutch lever at the left of the wheel up until it locks, push foot clutch in, and move pto gear lever to the left. Gears grind worse doing this and you may want to cut tractor off and engage pto gear lever. To start pto turning, push in the spring loaded top of the pto clutch lever and move the lever down slowly, don't jerk implement for obvious reasons. To stop implement,raise pto clutch lever until it locks. When the pto lever is up, it is applying pressure on the clutch throughout bearing so don't run tractor with lever up for more than a few minutes. When not using pto, disengage pto gear shift lever and leave pto clutch lever down.
Hope this helps. Oh, and I would get a manual from Long,now Farmtrac.

KEH




Follow Ups:




Post A Followup

Name:
E-Mail:

Subject: Re: Re: Long 460 pto questions

Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

Advertisement
12-volt conversion kits available for Ferguson Model TO30. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.    [Click here to visit this Sponsor]

Home

Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com

Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.