loader hydraulics question -part2
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MikeH-Tx on May 27, 2001 at 06:39:07 from (220.127.116.11):
My Kubota loader was getting sloppy and it was suggested here that I replace the seals inside the hydraulic cylinders. Good advice and I bought the kits. However, one of the seals is made of a material that doesn't expand like a rubber o-ring, yet needs to be stretched to get it on.
What is the secret to assembly for these kinds of materials? Get it hot first? Stretch it then compress it with something like a ring compressor?
After just stretching it on, I tried to just force it into the cylinder, but the screw threads buggered it all up. I don't want to try any more before knowing what I am doing.
By the way, I took a picture in case seeing the seal would help in the explanation. Click below to see the inside of the cylinder and the buggered up seal.
|12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|