[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greg on May 06, 2002 at 18:05:06 from (184.108.40.206):
All right you JD experts. 2955 high/low unit. TM 4449 shows a "valve ball" near a priority valve, and the illustraion is not clear as to where it goes-behind the priority? in the cavity of the housing that the priority plugs into? Better yet, upon disassembly, there was no "ball" in any of the passages that I saw. Searching around, I did find a leather disc approx. 1/4 inch diameter and 1/16 thick laying in the bottom of the clutch housing. Could this be the "valve ball"? And still, where does that sucker go? Teardown was because hi/lo would intermittently kick in and out (disengage). Also would occasionally whine when shift was made to high. Shift quality seemed to be quite slow and noisy. Found nothing obviously bad, but did put in a new pump due to some marginal scoring in housing, resealed everything I could lay my hands on, final issue seems to be this "valve ball". If any of you guys can shed some light on this, I would really appreciate it. Dealers around here seem to scratch their heads when mentioning this part. In advance, Thank You.
|12-volt conversion kits available for Ferguson Model TO30. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|