Bush Hog Vibration
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T-Bone on November 01, 2000 at 08:05:50 from (184.108.40.206):
I have a 5' Bush Hog brand rotary cutter model sq600 that I bought new this summer. The first on vibrated so bad it shook the whole tractor. I called Bush Hog and they sent someone out to replace it. They said that the stumpjumper had been drilled off center. The one they brought did better but still shakes and rattles, especially if a blade of grass gets between the stumpjumper and the blade. I pulled the blades, polished the area where they are bolted on, even greased that area. It did pretty good until another blade of grass got back in there. I will never buy another Bush Hog implement. I always thought they were the best. The one I had before this one was a super cheap, light duty and it did a lot better job. Go figure.
|12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|