1980 Kabota L245DT
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by needit on September 05, 2002 at 17:57:53 from (184.108.40.206):
I need a knowledgable person's advice on getting the final drive (right side) to this tractor fixed? All the bearings and three smaller bevel gears are bad along with the two connecting housings. The contact points (seals areas) between them is worn and knurled up, a little too much I'm afraid. I have it all torn down and believe I can do the gears and bearings but the housings are the problem. I'm very concerned I won't be able to afford the costs to do this repair! The prices I received from the Kabota dealer for just the gears/bearings is outragous! Now the 2 housings appear bad too boot! Can i get them built-up (tig welded) and machined to OEM specs? Are remanufactured housings and/or complete final drives available? If so - where/whom? Could someone please explain why and how to set "gear backlash" (using shims)? Thanks kindly
|12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|