Re: bobcat 743 hydraulic question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by david val on March 19, 2004 at 10:56:57 from (188.8.131.52):
In Reply to: bobcat 743 hydraulic question posted by Danny on March 17, 2004 at 16:24:29:
i don't know the 743, but if is hydrostatic, then the motor is coupled to the hydrostatic (travel) pumps. the hydraulic pump, which is also the hydrostatic charge pump, is attached to these pumps. if you stopped the engine immediatly after it stopped moving, there is a chance that there is no damage. you have to replace the burst line (while exercising EXTREME clealiness), add oil and try it. if it worked more then a few seconds in high rpm without oil, there is a cance of a damage.
|12-volt conversion kits for the following Ford models: 9N, 2N, 8N, NAA/Golden Jubilee, 600,601 series, 700,701 series, 800,801 series, 900, 2000, 3000, 4000. Contains parts and instructions for updating older 6-volt tractors to 12-volt charging system.
[Click here to visit this Sponsor]|
Reproduction of any part of this website, including design and
content, without written permission is strictly prohibited.
Copyright © 1997-2013 TodaysTractors.com
|Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others.|